创客百科

姿势共享,有节操无门槛参与的创客百科,创客动力之源 \ (^_^) /

用户工具

站点工具


en:arduino:language:volatile

volatile keyword

volatile is a keyword known as a variable qualifier, it is usually used before the datatype of a variable, to modify the way in which the compiler and subsequent program treats the variable.

Declaring a variable volatile is a directive to the compiler. The compiler is software which translates your C/C++ code into the machine code, which are the real instructions for the Atmega chip in the Arduino.

Specifically, it directs the compiler to load the variable from RAM and not from a storage register, which is a temporary memory location where program variables are stored and manipulated. Under certain conditions, the value for a variable stored in registers can be inaccurate.

A variable should be declared volatile whenever its value can be changed by something beyond the control of the code section in which it appears, such as a concurrently executing thread. In the Arduino, the only place that this is likely to occur is in sections of code associated with interrupts, called an interrupt service routine.

Example

// toggles LED when interrupt pin changes state
 
int pin = 13;
volatile int state = LOW;
 
void setup()
{
  pinMode(pin, OUTPUT);
  attachInterrupt(0, blink, CHANGE);
}
 
void loop()
{
  digitalWrite(pin, state);
}
 
void blink()
{
  state = !state;
}

Reference Home

本页面的其他翻译:
en/arduino/language/volatile.txt · 最后更改: 2016/12/25 22:15 (外部编辑)