创客百科

姿势共享,有节操无门槛参与的创客百科,创客动力之源 \ (^_^) /

用户工具

站点工具


en:arduino:libraries:stepperstep

Stepper: step(steps)

Description

Turns the motor a specific number of steps, at a speed determined by the most recent call to setSpeed(). This function is blocking; that is, it will wait until the motor has finished moving to pass control to the next line in your sketch. For example, if you set the speed to, say, 1 RPM and called step(100) on a 100-step motor, this function would take a full minute to run. For better control, keep the speed high and only go a few steps with each call to step().

Parameters

steps: the number of steps to turn the motor - positive to turn one direction, negative to turn the other (int)

Returns

None

See also

  • Stepper(steps, pin1, pin2)
  • Stepper(steps, pin1, pin2, pin3, pin4)
  • setSpeed(rpm)

Reference Home

本页面的其他翻译:
en/arduino/libraries/stepperstep.txt · 最后更改: 2016/12/25 22:15 (外部编辑)